Aesus Economy Shrink Banding Labeler and Neck Bander

from 60/min up through 200/min on neck bands

Simple and Compact Economy Sleeving

The Aesus Economy range of Neck Banding/Sleeving machines are very compact and affordable.

Speeds 100/min on reasonable sized sleeves. Faster on Neck bands (200 per minute).

Sleeves up to 4.375 inch dia (100mm) (170mm) flat width.

Apart from inherently well designed machinery including oversized supports, stainless steel panels, optional safety guarding, compact footprint and other excellent features too numerous to mention, ShrinkBanders have certain very exclusive advantages that we list below.

Mandrel application Bands or Sleeves are applied to the container, directly from the mandrel. This means there is no secondary side transfer or vacuum cups or other movement. Sleeves go right on the container.

Close sizing of Mandrel, band and container As we apply directly from the Mandrel we can have a band that more closely fits the container, thereby saving band material cost, and giving better final shrink characteristics. The closer the band fits the container the smaller percentage of shrink needed. No suction cups.

Direct application again means that neither suction cups nor vacuum is needed to hold the band. Neither humidity, dust, nor worn suction cups have any effect on the machine.

Static Electricity As the bands are not released until they are on the container static electricity has virtually no effect. If you have very short bands and lots of static then our proprietary band tacker can be enabled right at the application station to ensure the band stays put.

Large Bands The larger the container diameter the better our machines stand up against the competition because we control the band right onto the neck, and then if needed tacked. Short Bands Very short bands (3mm or so) can be applied by our ShrinkBanders, where other machines lose total control.

Band Tacker Our own optional proprietary single or dual band tackers can enabled to tack the band to the container. This is activated directly from the control panel, and saved away as a recipe to be recalled for subsequent use once setup correctly.

Dial in any length at the control panel using our unique is servo band feed mechanism. Recall recipes for subsequent set ups. Print registration Both clear and printed band material can be run on the same machine with the optional photo registration device.

Changeover: new products can be set up quickly and easily. The time saved adds up rapidly... helping pay for the machine over and over.



Compact: The Shrinkbander takes up half the space of others.


We use Servo and not Stepper drives to feed the band, and to power the cutting blades.

Simple controls

Simple ergonomic operator panel shows machine status, controls all options, has memories to recall previous set-ups, and is password protected where necessary.

Optional Accessories

Photo Registration for Printed Band Material, stops the feed at the length determined by photo registration marks on the Material.

Automatic Motorized Band Unwind, operates using a low level sensor which detects when the band unwind should feed band to alleviate web tension.

Vertical Perforation Assembly, always combined with the motorized band unwind, a hardened perforation wheel perforates the sleeve. Note with our system no additional tension is given to the web by the perforation wheel because of the motorized unwind. The Perforation placement on the band can be adjusted anywhere horizontally along the material’s layflat.

Horizontal Perforation Assembly Allowing the cap to be removed from the container while leaving the sleeve on the the container.


Speeds and Sleeves

Click Here for more information on Sleeve Materials and speeds.

  • Video Eco Shrink LB

    Click Image below for Video - Aesus Economy Neck Bander

  • Video Aesus Eco Shrink MB

    Click Image below for Video - Aesus Eco MB Shrink Sleeving with Hybrid Tunnel

  • Top